Open a Western Digital Passport Portable 250GB

Western Digital 250GB Passport portable hard drive allows you to add a large amount of storage to almost any computer within minutes. Despite the high marks and very reliable in general, and the hard drive in case the passport system uses a rotating dish. Like any mechanical system, do not fail passport holders at the end of the day at some point, and how it is being how tips to tell you these points
Q 1
Shut down the computer that you are connected to the Western Digital Passport drive. Unplug the USB cable from the external drive and the computer.
Q 2
Close the cover of the slide that protects the input ports on the disk if it has such a passport cover - and not just to do.
Q 3
Hold a passport so you can view side of the drive that contains the connection port USB. Insert the tip of a flathead screwdriver in the small curved incision on the side of the engine - and the other side is relatively flat.
Q 4
Insert a screwdriver in the slot firmly, but gently. Turn slowly half-turn of a screwdriver in a clockwise direction, or to the right. The interior of the casing separates slightly from the outer shell.
Q 5
Turn the passport all over so that you view the other side of the drive. Insert a screwdriver tip in a small incision - again, next to the curved edge - turn a screwdriver and twist in a clockwise direction and a half.
Q 6
Slide the inner part of the outer casing of the box.
Q 7
Disconnect cable connector from the hard disk that leads to the circuit board. Remove the screws that guarantee the preservation of the drive to the inside of the box with the Phillips screwdriver.
Q 8
Replace the internal drive with a new one. Reassemble passport holders by reversing the steps used to disassemble it.